Frame and gas bottle holding clamp made from 3CR12 " href="http://issuu.com/frontrunner4x4/docs/ferritics_utility/2?e=6782228/7819532" target="_blank">3CR12 stainless steel.
Powder coated black and lockable clamp.
The gas bracket mounts a 5kg, 7lb or 10lb gas bottle on the gutter of the Land Rover Defender 90 110.
The bracket is designed to fit on the right rear of the vehicle.
Great Product- adjustment necessary for most gas bBy: Taylor Thorne on 29 August 2018As above, it doesn't fit all the Australian gas bottles. Daniel, being the legend he is, let me know ahead of time and recommended just relocating the latch to give the round bracket the appropriate clearance to hold the gas bottle. Even with the adjustment, I am more than happy with this product.
Struggle with Australian Gas BottlesBy: Peter on 10 August 2018If you intend to fit an Australian 4.5kg "Swap-and-Go" bottle, then this holder won't fit that bottle. Daniel did advise me of that when I ordered it - so I was aware. I modified my holder by cutting the rounded bracket in half and then bolting the two halves onto the rear plate. This is a bit messy but works. Be careful about the positioning of the holder so that the back door can fully open without colliding with the gas bottle or holder. I went on a 1800km trip in early June, 400km of it was off-road in the Vic high country. The holder didn't miss a beat. Therefore I judge it to be pretty robust. A design improvement would be to properly clamp the holder to the gutter rather than just hooking over the top and pulling down. That will be a modification I will make in the near future.
Gas bottleBy: Alejandra Zions on 23 September 2017Nice product easy to install on my defender. Had trouble finding gas bottle that fits! Eventually found one at super cheap auto.